KCU105 based control and data acquisition

gig_ethernet_pcs_pma_0 (V15.1)

• Clear Board Parameters
• Data Rate 1G
• Standard SGMII
• Core Functiionality ** LVDS Serial ** Ref Clk 625MHz
• Management Options ** NO MDIO ** Yes Auto Negotiation
• NO SGMII PHY Mode
• Include Shared Logic in Core

tri_mode_ethernet_mac_0 (V9.0)

• Clear Board Parameters
• Data Rate 1G
• Interface ** PHY Interface: internal ** MAC Speed: 1000Mbps ** internal mode clock source: user clk2 ** Management Type: AXI4-Lite, Frequency 125.00MHz ** YES MDIO and IO Buffers
• Features ** Check Statistics (64-bit) and Statistics Reset only

Generate the project after git clone:

Make sure there are following lines in config/project.tcl:

    # Create project
    create_project top ./ # possibly with -part xcku040-ffva1156-2-e

then

    mkdir top; cd top/
    vivado -mode tcl -source ../config/project.tcl
# open GUI
    start_gui
# start synthesis
    launch_runs synth_1 -jobs 8
# start implementation
    launch_runs -jobs 8 impl_1 -to_step write_bitstream
# or do everything in tcl terminal
    open_project /path/to/example.xpr
    launch_runs -jobs 8 impl_1 -to_step write_bitstream
    wait_on_run impl_1
    exit

project.tcl is generated via File->Write Project Tcl with everything unchecked.