This software allows to forward sensor data from sensor connected via OpenZen to ROS version 2.
OpenZen is a library for high performance sensor data streaming and processing and supports multiple sensor models: https://bitbucket.org/lpresearch/openzen/
IMU is definited in ENU. With positive gravity values in z direction. All orientation changes are based on the right hand rule.
After this call, you should logout and login with this user to ensure the changed permissions are in effect.
To allow access to sensors connected via USB, you need to ensure that the user running the ROS sensor node has access to the /dev/ttyUSB devices. You can do this by adding the user to the dialout group.
sudo adduser <username> dialout
To compile this driver in your ROS2 setup, follow these steps:
mkdir -p ros_ws/src
cd ros_ws/src
git clone --recurse-submodules https://bitbucket.org/lpresearch/openzenros2.git
# get your ROS2 environment going
source /opt/ros/foxy/setup.bash
cd ..
colcon build
source ./install/setup.bash
You can now run the OpenZen ROS2 driver with this command in the window you used to compile the software:
ros2 run openzen_driver openzen_node --ros-args --remap __ns:=/openzen
By default, it will connect to the first available sensor. If you want to connect to a specific sensor, you can use the serial name of the sensor as parameter, for example:
ros2 run openzen_driver openzen_node --ros-args --remap __ns:=/openzen -p sensor_name:="LPMSCU2000573"
If your sensor is configured for a different baud rate, you can use the baudrate parameter to give a specfic baud rate setting:
ros2 run openzen_driver openzen_node --ros-args --remap __ns:=/openzen -p sensor_name:="LPMSCU2000573" -p baudrate:=115200
Now you can print the IMU values from ROS with:
ros2 topic echo /openzen/data
To output the values of a GPS unit (if available) use this command:
ros2 topic echo /openzen/nav
Or plot some values (for example linear acceleration) with
ros2 run rqt_plot rqt_plot /openzen/data/angular_velocity
We have prepared a sample launch file openzen_lpms.launch to demonstrate data acquisition and plotting using openzen_sensor_node:
ros2 launch openzen_driver openzen_lpms.launch.py
To change to autocalibration setting via the command line:
ros2 service call /enable_gyro_autocalibration std_srvs/SetBool "{data: true}"
To trigger an gyroscope calibration:
ros2 service call /calibrate_gyroscope std_srvs/Trigger