bl808_linux

bl808 Linux

.
├── bl808_dts         # kernel dts file
├── bl_mcu_sdk_bl808  # bl_mcu_sdk for build low load bin
├── build.sh          # build script
├── linux-5.10.4-808  # linux kernel code
├── opensbi-0.6-808   # opensbi code
├── out               # bin file output dir
├── toolchain         # build need toolchain
└── README.md         # readme file

Environment Setup

Ubuntu20.04 needs to use apt to install the package:

sudo apt install flex bison libncurses-dev device-tree-compiler lz4

Download toolchains

mkdir -p toolchain/cmake toolchain/elf_newlib_toolchain toolchain/linux_toolchain
curl https://cmake.org/files/v3.19/cmake-3.19.3-Linux-x86_64.tar.gz | tar xz -C toolchain/cmake/ --strip-components=1
curl https://occ-oss-prod.oss-cn-hangzhou.aliyuncs.com/resource//1663142243961/Xuantie-900-gcc-elf-newlib-x86_64-V2.6.1-20220906.tar.gz | tar xz -C toolchain/elf_newlib_toolchain/ --strip-components=1
curl https://occ-oss-prod.oss-cn-hangzhou.aliyuncs.com/resource//1663142514282/Xuantie-900-gcc-linux-5.10.4-glibc-x86_64-V2.6.1-20220906.tar.gz | tar xz -C toolchain/linux_toolchain/ --strip-components=1

Compile

Step by step

./build.sh --help
./build.sh opensbi
./build.sh kernel_config
./build.sh kernel
./build.sh dtb
./build.sh low_load
./build.sh whole_bin

Or

./build.sh all

Then find the firmwares under out

├── fw_jump.bin
├── hw.dtb.5M
├── Image.lz4
├── squashfs_test.img 
├── low_load_bl808_d0.bin 
├── low_load_bl808_m0.bin 
├── merge_7_5Mbin.py
└── whole_img_linux.bin

Download Firmware

Get the latest version of DevCube from http://dev.bouffalolab.com/download
Connect BL808 board with PC by USB cable
Set BL808 board to programming mode
- Press BOOT button
- Press RESET button
- Release RESET button
- Release BOOT button
Run DevCube, select [BL808], and switch to [MCU] page
Select the uart port and set baudrate with 2000000
M0 Group[Group0] Image Addr [0x58000000] [PATH to low_load_bl808_m0.bin]
D0 Group[Group1] Image Addr [0x58000000] [PATH to low_load_bl808_d0.bin]
Click 'Create & Download' and wait until it's done
Switch to [IOT] page
Enable 'Single Download', set Address with 0xD2000, choose [PATH to whole_image_linux.bin]
Click 'Create & Download' again and wait until it's done

Boot BL808 board

Press and release RESET button, E907 will output log by IO14(TX)/IO15(RX) and C906 by IO5(RX)/IO8(TX)

License

Zagitta/bl808_linux

About

Resources

License

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Languages

Packages