"Remote Admin via MQTT Bridge - Nodes separated geographically (2.6+ firmware)" #7482
-
|
Hi! I have nodes separated geographically that can only communicate via MQTT bridge Topology: [Target Node] ←LoRa→ [MQTT Router 1] ←MQTT/Internet→ [MQTT Router 2] ←direct→ [Admin Node] Is remote administration possible through this MQTT bridge setup? Firmware: 2.6+ on all nodes |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments
-
|
It's possible, but not using the public/community MQTT server. You have 3 hops there, and the public/community MQTT server has a zero hop policy: https://meshtastic.org/docs/software/integrations/mqtt/#zero-hop-policy |
Beta Was this translation helpful? Give feedback.
-
|
"Thanks @fifieldt! I'm using a private MQTT server (not the public one), so the zero-hop policy shouldn't apply. I test the setup. |
Beta Was this translation helpful? Give feedback.
It's possible, but not using the public/community MQTT server. You have 3 hops there, and the public/community MQTT server has a zero hop policy: https://meshtastic.org/docs/software/integrations/mqtt/#zero-hop-policy