Twisted Part

[RickyIlBoss]

Good morning, I'm new to cadquery.... and I would like to know how to build this piece that I attached below.... how do you create it, because seeing in some videos on YouTube, they first create two separate pieces like I did and then connect the vertices or edges where the connection needs to be made and then click on the fusion curve from that I remember it was called that on freecad or other software..... on cadquery I don't know how to make this piece.... I tried to do twistExtrude but everything goes wrong.... I would like to first create the two pieces and the angle I want and then connect them like this piece that I attached..... I hope someone can explain it to me🙏 Thanks have a good day

[adam-urbanczyk]

It is definitely possible. Could you share your code first?

[RickyIlBoss]

import cadquery as cq

reslt=(
       cq.Workplane()
       .moveTo(0,10).radiusArc((0,-10),-10)
       .hLine(10).vLine(20).hLine(-10).close()
       .workplane().circle(10/2).extrude(4)
      )


result=(
        reslt.mirror("YZ").translate((44,0,0)).rotate((0,0,0),(1,0,0),90)
        )

This is my code, I just created the pieces as mentioned...but now I'm at the point of how to connect the lines to the vertices or edges as in the sketch. Thanks

[RickyIlBoss]

Good morning, did you receive the message with the code I sent you? I hope I didn't send it incorrectly. Thanks.

[RickyIlBoss]

It is definitely possible. Could you share your code first?

import cadquery as cq

reslt=(
cq.Workplane()
.moveTo(0,10).radiusArc((0,-10),-10)
.hLine(10).vLine(20).hLine(-10).close()
.workplane().circle(10/2).extrude(4)
)

result=(
reslt.mirror("YZ").translate((44,0,0)).rotate((0,0,0),(1,0,0),90)
)

This is my code, I just created the pieces as mentioned...but now I'm at the point of how to connect the lines to the vertices or edges as in the sketch. Thanks